Section 4 - Control Panel Installation
 
Page 2 of 30
 

Installing the optional Dead Front

Follow these steps to properly install the DF-50 dead front panel into the control panel cabinet.

  1. Remove the top two annunciator screws. Do not discard them because they will be reused.
  2. Set the dead front into the cabinet as shown in the figure below.
  3. Reinsert the two annunciator screws.
  4. Insert the two screws with the star washers into the bottom of the cabinet to secure the dead front into place.

Dead Front Removal

Follow these steps to properly remove the dead front panel from the control panel cabinet.

  1. Remove the two annunciator screws. Do not discard them.
  2. Remove the two screws and star washers from the bottom of the cabinet.
  3. Remove the dead front panel from the control panel cabinet.
  4. Reinsert the two annunciator screws.

 
Page 2 of 30