 |
 |
 |
|
Page
1 of 12
|
| Section 3-2 describes how to install the SK-5235 Remote Annunciator, SK-5217 Zone Expander, and the SK-5280 Status Display Module along with other accessory devices. |
Setting ID Codes
Before installing the SK-5235, SK-5217 or SK-5280, you must first set their identification codes. Each like device must be given its own identification codes. For example: each SK-5235 needs a unique ID code, but a SK-5235 can have the same ID code as a SK-5217. Each type of device has it’s own devices type programmed into it enabling the control panel to distinguish between the different devices.
On the back
of each device is a small 4-position dip switch used to set the ID code. Use
the chart below to determine the dip switch positions for each possible ID
code.
|
ID Number
|
Switches
|
|||
|
1
|
2
|
3
|
4
|
|
| 0* | Down | Down | Down | Down |
| 1 | Up | Down | Down | Down |
| 2 | Down | Up | Down | Down |
| 3 | Up | Up | Down | Down |
| 4 | Down | Down | Up | Down |
| 5 | Up | Down | Up | Down |
| 6 | Down | Up | Up | Down |
| 7 | Up | Up | Up | Down |
| 8 | Down | Down | Down | Up |
*Not supervised Up=On Down=Off