 |
 |
 |
|
Page
1 of 6
|
| Section 6 contains information pertaining to the programming of the 5104 using the 5230 remote annunciator. All programming is stored in an EEPROM (Electrically Erasable Read-Only Memory) chip, which is non-volatile memory storage. The various areas of programming are referred to as programming steps. These steps are covered in greater detail throughout this section. |
Default User Codes
The 5230 uses two programmable user codes (Installer and Operator codes). This section will refer to the user codes as either the Installer Code or the Operator Code. The table below lists the factory default Installer and Operator codes.
|
User
Code
|
Factory
Default
|
| Installer Code |
5104
|
| Operator Code |
1111
|